Ours was PN 89458-78030
If you attempt to do it at the track - try your best to completely depressurize the DI fuel rail. The DI rail seemed to have a ton of residual pressure when uninstalling the original sensor even with running the system dry and disconnecting the supply line.
Pull the...
No clue - our tuner said it's been happening with some 2nd gen GRZ86s as well. I didn't do any digging as to whether it's the same (sensor) manufacturer.
I also recall there being an issue with 1st gen GRY oil pressure sensors that led to Toyota relocating them to the current position.
Just documenting this for others.
Our development car had a high pressure fuel sensor fail midcorner at high rpm on track (Sonoma Raceway) several weeks ago.
Ecutek / ECU did what it was supposed to do - it lost high pressure signal and instantly went into port injection only mode / limp mode...
-3 is the real time short term knock adjustment. -3 is the default meaning no advance or knock
24 is the long term knock adjustment. 24 means no knock / ignition retard and your calibration is happy with your fuel.
ACN91 here in California will be around 16-18 on stock tune (ignition retard)...
I’ve observed this on stock cars as well as my own on Ecutek. So I don't think it's an Ecutek bug.
I'm inclined to say it's "normal" - because we don't touch cold start / idle maps either.
Best theory I have currently is that it's the motor running intentionally lean to warm up the catalytic...
Ecutek can log this, OBDfusion as well.
You measure boost request vs boost actual... the lag is the latency between the curves. Post the manifold IAT as a secondary axis for heatsoak reference. X axis is time.
My point being you can measure lag based on boost target vs boost actual. And maybe consider WGDC.
There is 5 pages of discussion here and no measurements
The transfer case runs hot inherently because hypoid gearsets use face friction to transmit power. Not like a bevel gearset which you see in the rear differential. Packaging and airflow don't help - but it will overheat left to its own devices anyways.
The Evo transfer case I believe has 1...
Back in the 90s the street cars (Evo/STI) could benefit from inheriting technology development from the race programs, but the AWD tech is completely divorced from the road going cars now. The WRC racecars just use something like Sadev or Xtrac for the AWD drivetrain. So the road cars end up...
I guess I should definitively say - deleting the rear overdrive does not fix the AWD overheat issue. The TC still overheats (measured), and the factory controller still triggers overheat.
I don't think it's a worthwhile mod outside of heavy off road use where you might want to have locked 4WD...
The general consensus on the first fire was that owner was trying to get an insurance payout... I don't think that was a legitimate factory issue (in my opinion).
I personally know the 2nd fire owner. I don't think that was a factory defect either, although it was a Cylinder #1 failure. Not my...
The popular failure mode in the US seems to be Piston #1 shattering and then exploding out of the block.
I have not heard of any spun bearings. My oil analysis reports don’t show any signs of accelerated bearing wear either
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.