tonic
Totally Hooked
- Aug 31, 2023
- 217
- 701
As most of you know, GRY uses the GF1A transfer case to send power to the rear axle. This unit wasn’t developed specifically for the GRY, it has actually been in use across various Toyota and Lexus models since at least 2005, including the RAV4, NX, and others.
While many GF1A parts as shared, there are some differences. Most applications use a 41:18 gear ratio (0.439), while GRY uses 39:17 (0.436). Also, the output shaft on the GRY version is shorter. There are GF1A variants with a longer output shaft, like 2.5L XA50 RAV4 or Urban Cruiser, but I can't confirm that their dimensions match the GRY.
I’ve cross-referenced part numbers for the GRY transfer case housing, cover, input shaft (from the front differential), and bearings. These components are widely shared with other Toyota and Lexus models. That suggests it might be a direct fit for the GRY.
In theory, installing one of these transfer cases in the GRY (using either an adapter or the GRY output shaft) would yield a constant-speed AWD system, functionally similar to pairing the standard GRY transfer with the Rovanpera edition final drive at the rear.
While this might provide more consistent torque distribution on loose surfaces, I don’t see significant advantages for regular road or track use.
That said, there are YouTube builders claiming to have “corrected” Toyota’s design flaw by reverting to constant-speed AWD
I’ve picked up a 2012 Gen3 RAV4 (XA30) transfer case. I’ll be using it as a base to build and test cooling solution for my GRY. I’ll document the process and share updates here as I go.
While many GF1A parts as shared, there are some differences. Most applications use a 41:18 gear ratio (0.439), while GRY uses 39:17 (0.436). Also, the output shaft on the GRY version is shorter. There are GF1A variants with a longer output shaft, like 2.5L XA50 RAV4 or Urban Cruiser, but I can't confirm that their dimensions match the GRY.
I’ve cross-referenced part numbers for the GRY transfer case housing, cover, input shaft (from the front differential), and bearings. These components are widely shared with other Toyota and Lexus models. That suggests it might be a direct fit for the GRY.
In theory, installing one of these transfer cases in the GRY (using either an adapter or the GRY output shaft) would yield a constant-speed AWD system, functionally similar to pairing the standard GRY transfer with the Rovanpera edition final drive at the rear.
While this might provide more consistent torque distribution on loose surfaces, I don’t see significant advantages for regular road or track use.
That said, there are YouTube builders claiming to have “corrected” Toyota’s design flaw by reverting to constant-speed AWD
I’ve picked up a 2012 Gen3 RAV4 (XA30) transfer case. I’ll be using it as a base to build and test cooling solution for my GRY. I’ll document the process and share updates here as I go.
