GR Yaris GF1A Transfer Case

tonic

Totally Hooked
Joined
Aug 31, 2023
Messages
217
Reaction score
701
As most of you know, GRY uses the GF1A transfer case to send power to the rear axle. This unit wasn’t developed specifically for the GRY, it has actually been in use across various Toyota and Lexus models since at least 2005, including the RAV4, NX, and others.

While many GF1A parts as shared, there are some differences. Most applications use a 41:18 gear ratio (0.439), while GRY uses 39:17 (0.436). Also, the output shaft on the GRY version is shorter. There are GF1A variants with a longer output shaft, like 2.5L XA50 RAV4 or Urban Cruiser, but I can't confirm that their dimensions match the GRY.

I’ve cross-referenced part numbers for the GRY transfer case housing, cover, input shaft (from the front differential), and bearings. These components are widely shared with other Toyota and Lexus models. That suggests it might be a direct fit for the GRY.

In theory, installing one of these transfer cases in the GRY (using either an adapter or the GRY output shaft) would yield a constant-speed AWD system, functionally similar to pairing the standard GRY transfer with the Rovanpera edition final drive at the rear.

While this might provide more consistent torque distribution on loose surfaces, I don’t see significant advantages for regular road or track use.

That said, there are YouTube builders claiming to have “corrected” Toyota’s design flaw by reverting to constant-speed AWD :)

I’ve picked up a 2012 Gen3 RAV4 (XA30) transfer case. I’ll be using it as a base to build and test cooling solution for my GRY. I’ll document the process and share updates here as I go.

tc01.webp


tc02.webp
 
Some progress on my TC cooling project.

I decided to go with OEM parts for reliability and future availability in case I need to replace anything later.

Pump: Brushless gerotor transmission pump from a Lexus RX. It’s light, quiet, and compact, with a built-in mesh filter, PWM control driver, and RPM feedback. This would allow smooth pump control and monitoring for abnormal operation. The internals are steel, so there’s no issue running GL-5 oil. Some aftermarket pumps use brass gears, which don’t hold up well with this type of oil.

Temperature sensor: My initial plan was to use the sensor from the GRY M/T gearbox and read the diff clutch pack (same part), which is also used in some Toyota 4x4 rear diffs running GL-5. Unfortunately, these sensors are either unavailable online or absurdly expensive, the local Toyota dealer wanted €180. So I went with a sensor from a BMW M2/M3 rear diff instead. It’s much cheaper and easier to source.

Control unit: I’m using an ESP32 for pump control. The main functions are already implemented: driving the pump’s PWM duty cycle, reading its RPM feedback, monitoring the temperature sensor, and measuring the pump’s current draw. Also logging everything to microSD card for better analysis.

Next step: install two temperature sensors in the TC of my Yaris to collect data and decide on location: drain vs fill plug.

setup.webp


lcd_1.webp


lcd_2.webp
 
I guess I should definitively say - deleting the rear overdrive does not fix the AWD overheat issue. The TC still overheats (measured), and the factory controller still triggers overheat.

I don't think it's a worthwhile mod outside of heavy off road use where you might want to have locked 4WD behavior.
 
Back
Top