Search results

Yup

Yea there is more space. But ingress/egress is still irritating with that lump under the AC vent, which is not trivial to remove/replace.

Gave my car a 50,000 km birthday present: 1. Redline MTLV for the gearbox 2. Redline 75w90 for the diff 3. Toyota 0w20 for the engine Also changed the PCV valve. Didnt think i needed to change cos i was running fine. But the PCV valve came out a little gunky and the balls barely rattled even...

Final piece of thr puzzle. 3D printed in Ti these, sanded/brushed them, then torch.

FWIW, as another data point. photos from my car. No wear marks. I did remove the hood liner since day 1 (i not claiming its the cause, just stating facts). 2022 JDM GR86 RC. VIN ZN80006569. Probably a series A or B. Mileage ~50,000km.

2 years and 50,000km. Only car. Daily it, sharing with my wife. Use it to ferry my 7 year old twins (though they would start to find the rear small in maybe 3 years time) 2 track days, 2 drift sessions and 3 autocross/gymkhana so far. Runs like new. Halo white paint is a biatch to maintain and...

Curious. Why do you say specifically 4th gear? Its the gear with the carbon synchro.

Really love the white on white tc4!

3.4lb saving only. See this entry in my build thread: https://www.gr-zoo.com/threads/white-gr86-from-singapore.1129/post-70995

Yes sir! A little off the shelf EDC knife that i screw onto the 3d printed back cover, to open fedex boxes of car parts now and then!

And this is the end state of my shifter escapade. Since i had replaced the shifter shaft anyway for the gated shifter project above, i made another, super short, shifter shaft cum knob thingy. Goal was to replicate the shifting action of an ND miata or FD3S shifter. Short wrist flicks, rather...

Reached the end state of the gated shifter. Works very well, but because i used back the stock socket/cradle of the pivot, the gate has to be much higher up in order for the fingers of the gate to not look too thin and wierd. Glad to have experienced a gated shifter once in my life. With all...

Machined Titanium cover, with a creme brulee torch hahahah!

Looks like it makes the throttle even more aggressive/non-linear?

Ah! So it fits! Ok! Thanks!!!

Wow carbon prop shaft! May i ask whats the make/model of the shaft? I had been monitoring Driveshaft Shop but they never had one listed for the new gen.

If anyone wants. https://www.thingiverse.com/thing:7009710 Fits the standard buttons on the front cover as well as the original silicone membrane/gasket for some water sealing. Didnt see anyone did that before. Took some iterations getting the fit right. Note, back cover need to tap M3x0.5...

Busy iterating with a H Pattern gate. Since I will not have the money to buy a Ferrari in this lifetime hahaha. Fretting with ideas on the reverse lock out. And how to blend it back into the center console. Suggestions welcome.

I felt part throttle pulling harder also. Was so curious that i dyno-ed it hahaha. Red is full stock exhaust (with GR intake, stock tune, no other power mods, i posted it before). Green is MAP headers (with same GR intake, stock tune) Pink is MAP headers (with same GR intake, stock tune), but...