GR86 What did you do with your GR86 today

The foam touches like it does in the picture. They suggest cutting the foam but I'm not doing that so didn't put the pins back in and just tucked them. Fitting was easy. It's nice the bracketry is there as if they knew people would use them for this.

Cost was about £120 plus postage but I'd ordered other bits too like the window aero bit (only £95) everyone gets and some wheel nuts for some future wheels and other bits. Was from Japan Parts but did get stung for the tax. Oddly today I've had some bits today from RHD Japan but didn't pay any extra so I'll be going there more often.
Been for a good drive yet ? Keen to know any differences noticed !
 
Happy a momentary panic when I walked out of work today to find what I thought was a scratch on my passenger rear quarter. Closer inspection showed that it was just some black marks, like something rubber had been dragged along the paint. Most of it came off with a wet thumb, but I couldn't get the worst of it off until I got home and rubbed it (fairly hard) using some tar remover on a cloth.

Luckily it's gone with no damage, but now I'm wondering where it came from. I only noticed it today as I came back to the car after work, but the carpark is just a small one for our small office block. The only cars there all day are the three belonging to my colleagues, and the only car parked on that side was my boss, who was in before me, and left after me. Haven't really been anywhere else. We do have some kids up the road who ride their bikes on the path outside our house sometimes and it did kind of look like it could be the the edge of a rubber handlebar...but I watch them like a hawk whenever I see them outside and they haven't got that close...yet. Time to spend the entire evening curtain twitching...
 
😀
DSC_0471.webp
 
Happy a momentary panic when I walked out of work today to find what I thought was a scratch on my passenger rear quarter. Closer inspection showed that it was just some black marks, like something rubber had been dragged along the paint. Most of it came off with a wet thumb, but I couldn't get the worst of it off until I got home and rubbed it (fairly hard) using some tar remover on a cloth.

Luckily it's gone with no damage, but now I'm wondering where it came from. I only noticed it today as I came back to the car after work, but the carpark is just a small one for our small office block. The only cars there all day are the three belonging to my colleagues, and the only car parked on that side was my boss, who was in before me, and left after me. Haven't really been anywhere else. We do have some kids up the road who ride their bikes on the path outside our house sometimes and it did kind of look like it could be the the edge of a rubber handlebar...but I watch them like a hawk whenever I see them outside and they haven't got that close...yet. Time to spend the entire evening curtain twitching...
Could it have been someone visiting your office with a drag along bag and walked between the cars? I always wince when I see that
 
Could it have been someone visiting your office with a drag along bag and walked between the cars? I always wince when I see that
Nah, where the car is parked is back up to a fence so no one would walk between the cars. And it's only a very small little office block on the high street....apart from our office, I think the only other business in the building is a little chiropodists, which has only a few clients visit per day, at most. And none of them parked near me.

Thinking about it though...on the way in, I took country lanes that had been coated with that tar and chip stuff they chuck down. Hopefully it was just a glob of tar that got chucked up and hit the side of the car. Given that it took a fair bit of elbow grease to remove, I figured something must have rubbed on the car but I guess tar might have just stained it.
 
Been for a good drive yet ? Keen to know any differences noticed !
Still hasn't left the garage. Really I should do every time I change something but my time is limited and rain is forecast so can't really push it. Fitted these tonight.
IMG_20240611_222929.jpg


More substantial than stock and I knew they'd fit with the Cusco strut brace I had. Only PITA was loosening the stopper as the end piece is only held in place and not screwed so easy to lose.
IMG_20240611_223959.jpg


Also finally joined the aero stabiliser club
IMG_20240611_214312.jpg
 
Confession, I too wasn't in the '86 today 🙁
Instead I was in Brescia for the start of the Mille Miglia, a great atmosphere around the town and amazing to see 450 classics being used.
A downpour just before the start made the corners slippy, one Porsche spun right in front of me. Loads of classic Ferraris and an unbelievable number of Merc 300 SLs.
They're off on a 1000 mile jolly and will be back in town Saturday night for prize giving.
20240611_113541.webp

20240611_134831.webp20240611_124044.webp20240611_133921.webp20240611_140308.webp20240611_141818.webp
 
Shakedown tonight before it rains. Rear now balanced with front. Turn in even sharper. I'm sure NVH is down a bit too. Could well be the thicker bars or a combination of that and the aero stabiliser. Need to keep driving it regularly to stay in tune. NVH is relative to me since I ride bikes. I find it pretty good. Onto the next bits.

IMG_20240612_214220.webp
 
On the A4 between Twyford and Hare Hatch they have just resurfaced the road using the loose stone method. No advance warning of this where you can turn off to use a different route. So I had a mile of stones peppering my car. They had used so many stones there were grooves made by tyres. Keep clear of this road for a few days. I am not happy.

After the horse has bolted I know, but just put an order in....
edited_Screenshot_2024-06-14-12-40-20-92_e4424258c8b8649f6e67d283a50a2cbc.webp
 
Last edited:
On the A4 between Twyford and Hare Hatch they have just resurfaced the road using the loose stone method. No advance warning of this where you can turn off to use a different route. So I had a mile of stones peppering my car. They had used so many stones there were grooves made by tyres. Keep clear of this road for a few days. I am not happy.

1000030662.webp
 
Fitted the RokBlokz (no-drilling) Splash Guards. Prepped screws by painting tops black. Attempted to fit them with wheels on, but it was almost impossible to get the purchase needed. So it was wheels off and all done and dusted within an hour. Lessons learned: Inserts could do with adhesive to stop them turning when screws inserted. Screws should be lubricated before inserting, otherwise you can’t nip up to a ‘stop’.
Otherwise all fixed safely.
IMG_6782.jpeg
 
Last edited:
Fitted the RokBlokz (no-drilling) Splash Guards. Prepped screws by painting tops black. Attempted to fit them with wheels on, but it was almost impossible to get the purchase needed. So it was wheels off and all done and dusted within an hour. Lessons learned: Inserts could do with adhesive to stop them turning when screws inserted. Screws should be lubricated before inserting, otherwise you can’t nip up to a ‘stop’.
Otherwise all fixed safely.
View attachment 28912
I've just awaiting delivery of mine. If they can't be fitted without taking the wheels off it looks as though I have to pay the garage to fit them. 😬 They look neat though.
 
Fitted the RokBlokz (no-drilling) Splash Guards. Prepped screws by painting tops black. Attempted to fit them with wheels on, but it was almost impossible to get the purchase needed. So it was wheels off and all done and dusted within an hour. Lessons learned: Inserts could do with adhesive to stop them turning when screws inserted. Screws should be lubricated before inserting, otherwise you can’t nip up to a ‘stop’.
Otherwise all fixed safely.
View attachment 28912
Any chance of some wider angle shots when you get a chance?

I'm still bitter about the Automotive Passion ones I bought, which was 60 quid for basically some rather rough cut acrylic plastic, which I had to hack up myself to include the vent holes, and was only for the fronts. Tempted to splash out (ha!) on something a bit better quality, and these look like a nicer finish.
 
Back
Top