GR Yaris Suspension Secrets Seat Lowering Bracket

As far back as she goes ie position 1 👍 seat goes down to just touching the plugs, which is fine for me as I don’t want it any lower 👍
Going to check mine to make sure it’s as far down as possible and clear of the plugs. And agreed on the rear bolts being somewhat awkward to tighten up.
 
Fitted the suspension secrets bracket today - what a difference it makes

bit fiddly to get to some of the bolts but nothing major I was quite easily able to get to the rear 4 bolts from putting my arm in from the front of the seat while pumped up

I moved the airbag plugs out of the way and gained a bit more of a drop but it’s really not necessary as a decent gain is still achieved with them in situ. I have mine set to just the point where the plastic trim is just passed touching the carpet. It goes a fraction more but it just starts pushing the trim into the floor and isn’t gaining anything

the seat position is way better now I would recommend this definitely

If someone short drives the car I would expect pumping the seat up high would raise it and move it forward enough to work but I don’t share the car and the access to the rear bench isn’t an issue either

04473CCA-B5A8-474F-AC80-8B00A651D52C.webp
F9A1A980-DC4A-4BDA-9A63-26F0FFAA1A50.webp
FF7186A8-DB8E-441C-8636-905AABB3E8B5.webp
 
Going to check mine to make sure it’s as far down as possible and clear of the plugs. And agreed on the rear bolts being somewhat awkward to tighten up.
If you leave the plugs on the shift plastic bracket they will clash with the seat base frame

Routing the wires under the frame gains more room
 
Ordering a drivers plate / bracket tomorrow. Did you guys take your seats fully out to remove the slider rails? If so, Did you disconnect your battery due to the seat airbag? Thanks in advance.
 
Ordering a drivers plate / bracket tomorrow. Did you guys take your seats fully out to remove the slider rails? If so, Did you disconnect your battery due to the seat airbag? Thanks in advance.
Full instructions on their website to download.

Battery needs disconnecting and seats come out to remove rails and secure to plates before returning into the car to secure in the desired position.
 
Full instructions on their website to download.

Battery needs disconnecting and seats come out to remove rails and secure to plates before returning into the car to secure in the desired position.
OK, Thanks for your reply.
 
I'm fine height wise in the drivers seat. It's the passenger seat I'd be happy to have a bracket for as anyone who sits in it looks 7 feet tall!! :oops: :ROFLMAO: 😅
 
I'm fine height wise in the drivers seat. It's the passenger seat I'd be happy to have a bracket for as anyone who sits in it looks 7 feet tall!! :oops: :ROFLMAO: 😅
Their £180 each or two for £240. Exact same item for pass and driver side. Wanna go halves on a set? Save £60 each! I only require a drivers lowering bracket haha
 
Their £180 each or two for £240. Exact same item for pass and driver side. Wanna go halves on a set? Save £60 each! I only require a drivers lowering bracket haha
Passenger side is different the bolts are staggered on the passenger seat

Ordering a drivers plate / bracket tomorrow. Did you guys take your seats fully out to remove the slider rails? If so, Did you disconnect your battery due to the seat airbag? Thanks in advance.
I didn’t disconnect the battery and had my seats out a few times now without issue

First time I did disconnect the battery I had to crawl through the back seats to reconnect it and open the boot but not had an issue leaving it connected

Just wait a few minutes after unlocking before disconnecting the plugs
 
Aww that's a shame they're different or that would have been a plan! 😅
 
I have decided to ditch both standard front seats and go with Cobra Nagoro bucket seats, so my RHD drivers side suspension secrets lowering frame is available. It’s one week old cost £200 selling for £170.00 including postage and packaging.
 
I have decided to ditch both standard front seats and go with Cobra Nagoro bucket seats, so my RHD drivers side suspension secrets lowering frame is available. It’s one week old cost £200 selling for £170.00 including postage and packaging.
Aren't they £180 new? Or have I missed something?
 
I'd have Recaro CS's trimmed with the OEM seat trim as a donor material if I was sure I was keeping the car for a decent amount of time to get the moneys worth of enjoyment... :love::cool:
 
I have decided to ditch both standard front seats and go with Cobra Nagoro bucket seats, so my RHD drivers side suspension secrets lowering frame is available. It’s one week old cost £200 selling for £170.00 including postage and packaging.
I may take that off you. Any damage / scratches to it while installing/ removing?
 
Thanks John!
Don't be shy... Let us all see your new front seats! Haha
 
Back
Top