Bobby basic question. Why might one use a camber arm on the rear over a camber bolt. One is 30 quid and the other is 300?
GR Yaris How far have you gone with your chassis mods? How far would you like to go?
- Thread starter StringTheoryGarage
- Start date
Why have a set of snap on spanners when you can do everything with a single adjustable from wilko? 
Sekred
Totally Hooked
- Dec 18, 2021
- 409
- 523
- 93
Okay, so this is my option.
The bolt is smaller in Dia because it is off-set meaning the torque is significantly lower the OEM bolt. Because the torque is lower, the clamping force is lower.
To state the obvious, because the clamping force is lower the joint may move under load.
This is reason I would not use them myself.
The bolt is smaller in Dia because it is off-set meaning the torque is significantly lower the OEM bolt. Because the torque is lower, the clamping force is lower.
To state the obvious, because the clamping force is lower the joint may move under load.
This is reason I would not use them myself.
The front bolts seem to be widely used rather than adjustable top mounts? Not seen to many complaints about them falling out of place?
