GR Yaris Corolla Style Rear Spoiler / Wing to fit GR Yaris.

HTAutos

Devoted member
Joined
Jan 18, 2022
Messages
59
Reaction score
112
Just testing the water before we go any further.
What are your thoughts if we made this Toyota Yaris GR rear spoiler?

winggr.webp
yargr.webp
grwing.webp
 
I quite like this! Would have to see it in the flesh though - something is definitely needed for the spoiler and this looks to be much better than the crappy Maxton lip I have on now.
 
I like it as a midway between the existing spoiler and something like the TOM’S which is quite large. Looks really nice
 
Like the idea of an OEM like spoiler, interested.

The side blade look is quite different from the Corolla. For the side blade view, not sure if the little vertical notch on the leading edge works aesthetically and the top upwards sweep I don't like much either, think I would prefer more of a mk3 Focus RS aestethic for the side blade, short upwards line and then flatter part that actually carries the wing.

Also I would like to see a bigger part of the wing floating and the middle part attached to the lid narrower and about same width as the 3rd brake light.
And actually aerodynamically speaking, I looks like the angle is too aggressive compared to the amount of air going under the wing, thus creating mostly drag rather then downforce....

Happy to receive a discount for my feedback ;)
 
Last edited:
If it's streetlegal in switzerland i would buy one. Really like the look.
 
Like the idea of an OEM like spoiler, interested.

The side blade look is quite different from the Corolla. For the side blade view, not sure if the little vertical notch on the leading edge works aesthetically and the top upwards sweep I don't like much either, think I would prefer more of a mk3 Focus RS aestethic for the side blade, short upwards line and then flatter part that actually carries the wing.

Also I would like to see a bigger part of the wing floating and the middle part attached to the lid narrower and about same width as the 3rd brake light.
And actually aerodynamically speaking, I looks like the angle is too aggressive compared to the amount of air going under the wing, thus creating mostly drag rather then downforce....

Happy to receive a discount for my feedback ;)
if it's any use, I agree with most things
 
Is there no way to blend this design into the original to make a one piece item that fits as a direct replacement for the original spoiler?
I'd be far more interested in something that looked 100% OEM rather than a 'bolt-on'
 
Last edited:
Is it bonded to the tailgate, or bolted? Looks good. (y)
 
Back
Top