Recent content by xpertleader

Registered in March 2021, £30,000 Located in Epping (CM16) Mileage: ~19,500 Selling my much loved GR as I'm making room for an incoming Caterham. The car has been carefully modified with premium parts for maximum performance on road and track. Total spend to get to this spec was circa £18k. All...

Hmm. Looking at this today and my wiring looks slightly different to yours (I've got a RHD car). Either that or I'm looking at it and can't see it!?

Thanks, I see that but I don't know which side on the receiving end it is (e.g. north or south in your picture). I assume the connected can only be oriented one way.

@tonic sorry for another novice question but do you know which pin is high/low on the H64 connector in your image? I'm trying to crimp the connectors without being in front of the car!

Thank you, both. I've just picked up the parts so hopefully will give this a shot soon.

Thank you! I'm going to try creating a cable from this to a female OBDII for the Aim Solo 2DL (similar to this approach). Were you able to draw power/gnd from somewhere nearby when you ran this on your GRY?

@tonic do you happen to know where I can buy the plug/pins for this H62 connection?

That's a very cool project. I'm a bit of a novice but wondering if there's a way I can create my own CAN protocol for the Aim Solo using the table you've shared. My assumption is that I'd need to connect to the CAN -/+ connector on the H62 - is there a different from this connection to the one...

Hi there, This is super interesting - thanks for sharing all the detail. I have an Aim Solo DL 2 which I've been trying to figure out how to properly plug into my GR Yaris in order to pick up more of these signals. With the stock OBDII connector (so far) I've only been able to pick up RPM...

Hi there, this is awesome - will be following closely! I was wondering where on the loom you're connecting to get your CAN H/L input signal?

Hey @MilanGRY really awesome looking car - congratulations. I spotted the mounting for the Aim Solo 2 DL - I actually ended up going the 3D printed route with mine so I can keep the shelf space for my phone. I'm interested to hear how you've got on with your Aim Solo? I have mine connected...